Filter
Top Products
20 Russound CA4 System Installation Manual
Source Audio Connections
The CA4 supports up to four audio sources. The Source Inputs are located on
the rear panel. Connect each source using quality RCA signal cables. Connect
the Left and Right Audio outputs from each source to the corresponding inputs
on the CA4 controller. Label each cable with the name of the selected source
and the Source Audio input number located on the CA4.
IR Connections
Each source component has a designated IR port on the rear of the CA4.
Attach the 1/8" plug end of the IR emitter to the IR emitter port labeled 1.
with the source number.
Remove the adhesive backing at the other end of the emitter and attach 2.
the emitter over the source component’s IR window.
In order to control this source component with IR, the source must be 3.
selected at the keypad receiving the command.
A common IR output is available for non specic source commands or to 4.
control additional non-source components.
CONTROLLER CONNECTIONS