Filter
Top Products
22 Russound CA4 System Installation Manual
REmOTE CONTROL pROGRAmmING
Programing a Device
To control universal TV, VCR or DVD, cable or satellite receivers, amplier or tuner, and
auxiliary devices with the CA4-RC you need to program the remote. You will need to
install the batteries and have enough room to point the CA4-RC at the various source
equipment. Before proceeding, nd the codes for the devices you want to program in
the “Manufacturer’s Codes”, and write them down or highlight them. Note: Record which
device is identied as Source 1, 2, 3, and 4.
Turn on the device and, if needed, load media.1.
Press the source key identied with that device. 2.
Press and hold SET until the red LED blinks twice, then release.3.
Enter the rst ve-digit code for your device. The LED blinks once as each digit is 4.
entered. If the code is correct, the LED blinks twice. Note: If the LED does not blink
twice, repeat steps 2 to 4 and try entering the code again.
Aim the remote at the device and press Power. The device should turn o. If it does 5.
not, repeat steps 3 to 5, trying each code for your brand until you nd one that
works. If you cannot nd a code that works, see Searching for Your Code.
Repeat steps 1 to 5 for the other devices you want to control. Write down each 6.
working device code.
S1 S2 S3 S4
Set - Press and Hold until
LED ashes appropriately
Power - Controls Source
On/O
LED - ashes indicating programming and talkback
Source - Selects source
to be controlled
Numeric Keypad - Enter IR
codes and numeric input
Checking the Codes
If you have set up the remote using the procedure in “Searching for Your Code,” you
may need to nd out which ve-digit code is operating your equipment. For example, to
nd out which code is assigned to your TV:
Press the source key to which the TV is assigned.1.
Press and hold SET until the red LED blinks twice, then release.2.
Enter 9-9-0. The LED blinks twice.3.
To view the code’s rst digit, press 1. Count the LED blinks (e.g., three blinks =3), 4.
and enter the number in the appropriate device listed in step 3 of "Programming a
Device." If a code digit is 0, the LED does not blink.
Repeat step 4 for the remaining digits, using 2 for the second digit, and so on.5.
To check for other device codes, repeat steps 1 to 5, using the appropriate key.6.
Searching for Your Code
If the device does not respond to the remote after trying all codes listed for your brand,
or if the brand is not listed, try searching for the code:
Press a source key once.1.
Press and hold SET until the red LED blinks twice, then release.2.
Enter 9-9-1, then the device group number (see below). The LED blinks twice.3.
0 Cable (Cable Converters, Video Accessories, Satellite Receivers)
1 TV (TVs)
2 VCR (VCRs, DVD players)
3 Audio (Audio Ampliers, Audio Amp/Tuners, CD Players)
Aim the remote at the device and press POWER. The remote sends IR codes from its 4.
library to the selected device, starting with the most popular code rst. If the device
responds, go to step 6.
If the device does not respond, press CH+. the remote will try the next code. 5.
Continue until the device responds. Press CH- to try the previous code.
Press SET to lock in code. To search for other device codes, 6. repeat steps 1-5.