Filter
Top Products
5
Panel Descriptions
fig.Panel.e
Front Panel
1.
PLAY/CLIP Indicator
Lights during playback of phrases.
Also lights during recording of phrases when the input level is too high
(at clipping level).
2.
REC Indicator
Lights during recording of phrases.
3.
Display
Phrase numbers are indicated here.
4.
MEMORY CARD Slot
Slot for inserting CompactFlash cards.
5.
Eject Button
Press to eject the CompactFlash card.
Rear Panel
6.
Ground Terminal
Depending on the circumstances of a particular setup, you may
experience a discomforting sensation, or perceive that the surface feels
gritty to the touch when you touch this device, microphones connected to
it, or the metal portions of other objects, such as guitars. This is due to an
infinitesimal electrical charge, which is absolutely harmless. However, if
you are concerned about this, connect the ground terminal (see figure)
with an external ground. When the unit is grounded, a slight hum may
occur, depending on the particulars of your installation. If you are unsure
of the connection method, contact the nearest Roland Service Center, or
an authorized Roland distributor, as listed on the “Information” page.
927
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the
event of lightning)
7.
Audio I/O Terminals
Terminals for input and output of analog audio.
8.
INPUT VOLUME Knob
Adjusts the volume level of signals input to the audio input terminals.
9.
Control/Power Input Terminals (CONTROL A)
Terminals for external control signals used to control the AR-200S and for
connecting to an external DC power supply (p. 10, p. 11).
* The terminal block features a protective cover. Be sure not to lose the cover when
making connections to the terminals or other times when the cover is removed.
Also be sure to keep the removed cover out of the reach of children.
10.
Control I/O Terminals (CONTROL B)
Terminals for external control signals used to control the AR-200S and for
connecting to an external DC power supply (p. 10, p. 11, p. 12, p. 13, p.
15, p. 23).
11.
RS-232C Connector
Allows for communicating with computers or other equipment (p. 9, p.
17).
12.
AC Adaptor Jack
Accepts connection of the supplied AC adaptor.
* Be sure to use only the PSB-1U AC adapter.
Bottom Chassis
13.
REC MODE Switches
Used for recording settings (p. 14).
14.
MODE Switches
Used for switching the playback mode and output level (p. 22).
* Depending on the playback mode (p. 10), a phrase with a different number than
the one displayed may be played back.
1
7 8 9 11
2 3 4
6 10 12
5
Bottom Chassis
13 14
Display Examples
AR-200S Status
Display
Stopped
The phrase number of the
currently selected phrase
is indicated.
When a phrase without
any data recorded to it is
selected, the phrase num-
ber flashes.
During Phrase
Playback
The phrase number of the
phrase currently playing
is indicated, and the four
dots light.
During playback of a
MIDI phrase, the phrase
number flashes and the
four dots light.
During Phrase
Recording
The phrase number of the
phrase currently being re-
corded is indicated, and
the four dots flash.
AR-200S_e.book 5ページ ２００５年１２月８日 木曜日 午前９時３分