Filter
Top Products
22
MODE SW Settings
In addition to the REC MODE switches (p. 14), the AR-200S’s bottom panel
also houses the MODE switches. Various applications are possible by changing
the settings of the MODE switches.
Each switch is ON when in the upward position, and OFF when in the
downward position.
When the AR-200S is shipped from the factory, all switches will be OFF.
* Use a pointed object to change the ON/OFF settings of the MODE switches.
* Set the MODE switches with the power to the AR-200S turned off.
fig.ModeSW
SW 1, 2: Playback Mode Settings
The AR-200S’s playback modes (p. 10) are set by means of varying
combinations of ON and OFF settings for SW 1 and 2.
SW 3: Output Level Setting
Specifies the output level. Set this in accordance with the specifications for the
device to which the playback is being output.
OFF: -10 dBV
ON: +4 dBu
SW 4: Programmed
Ordinarily, this should be set to “OFF.”
SW 5: Update Mode
Set this to “ON” when updating the AR-200S with the program files on a
CompactFlash card or writing AR-200S programs to CompactFlash cards.
Ordinarily, this should be set to “OFF.”
SW 6: Terminal Rec Setting
When conducting Terminal Rec (p. 14), set this to “ON.”
MODE Switch Specifications
PLAYBACK MODE
SW 1 SW 2
Playback by Card Data
OFF OFF
Direct Playback (Last-In) ON OFF
Binary Playback OFF ON
Interval Playback ON ON
AR-200S_e.book 22 ページ ２００５年１２月８日 木曜日 午前９時３分