Filter
Top Products
16
Recording Instructions (Terminal Rec)
Playback
9: 1 (On)
10: 0 (Off)
The specified phrase is played back.
Even when control signals are input continuously, the phrase is played back
one time only and then ends.
fig.CtrIn-Rec04.e
* Playback does not begin if the binary-specified phrase is empty (the playback
instruction is disabled). When playing back, specify a phrase that has already
been recorded.
Delete
9: 1 (On)
10: 1 (On)
First, when ON is input to Port No. 10, and then ON is input to Port No. 9,
deletion of the specified phrase begins. Deletion ends when the signal from the
CONT OUT connector confirming the presence or absence of the phrase
changes to OFF.
* Deletion does not begin if the binary-specified phrase is empty (the delete
instruction is disabled). When deleting, specify a phrase that has already been
recorded.
fig.CtrIn-Rec05.e
Note that the way phrases are specified in Terminal Rec differs
from that used in Binary Playback.
Example:
Binary specification of Phrase 112 (Phrase #: 112)
Convert the phrase number to a binary signal number.
“0” (Off), “1” (On)
The phrase number “0001” is specified in the binary notation as
“00000000,” and as shown in the
Phrase Number / Binary Signal chart
(p. 13), each subsequent specification is shifted by one.
fig.CtrIn-Rec06.e
The phrase number “112” becomes the binary signal “01101111.”
Timing Chart (PLAY)
Tpw
Tbps
Tbph
Tbpd
Tvpd
Tvbd
(msec)
20
200
100
–
–
–
–
–
–
300
300
100
min max
Tvbd
Tpw
Tbps
Tbph
Tbpd
Tvpd
Audio Output
Busy Out
Port No.9
Binary Specification
Port No.1–8
: Play Pulse Width
: Binary Setup Time
: Binary Hold Time
: Busy Delay Time
: Audio Delay Time
: End Busy Delay Time
Timing Chart (Delete)
Trdw
Tpds
Tpdh
Tprd
Tbds
Tbdh
Tbcd
Tpdd
100
50
50
0
200
20
–
–
–
–
–
–
–
–
250
*2500(typ.)
min max
(msec)
Tpdd
Trdw
Tpds Tpdh
Tprd
Tbds
Tbdh
Tbcd
Port No.10
Binary Specification
Port No.1–8
Port No.9
(the presence or absence
of phrases)
Control Out
: Delete Rec Pulse Width
: Delete Play Setup Time
: Delete Play Hold Time
: Delete Play Rec Delay Time
: Delete Binary Setup Time
: Delete Binary Hold Time
: Binary Phrase Output Delay Time
: Play Phrase Output Delay Time
*Play phrase output delay time is dependent on the card used.
To Specify Phrases with Binary Signals
001 00000001
002 00000010
003 00000011
004 00000100
005 00000101
006 00000110
007 00000111
87654321
Phrase
001 00000000
248 11111000
249 11111001
250 11111010
No.Port
No.
AR-200S_e.book 16 ページ ２００５年１２月８日 木曜日 午前９時３分