Filter
Top Products
21
Regarding Cards
The following table shows recording times available for cards formatted for
the AR-3000.
* Recording times listed are for mono recording. Recording times are halved when
data is recorded in stereo.
* These times are for when 1 phrase is recorded continuously, and are provided for
your reference when recording. The recording time will depend on the
combination of the grade settings of each phrase recorded in each memory card.
* Minimum recording times are listed only for MODE2. Depending on
conditions, you may be able to attain recording times longer than listed here.
When a piece of Phrase data recorded by the AR-200S, the settings of data on
the card will be as follows.
If you will be using the card on the AR-3000, refer to this list.
When cards created with an AR-3000 are played back on an AR-200S, the
resulting playback could diverge from the original. This is due to a variety of
factors, including the fact that data created for settings specific to the AR-3000
cannot be used by the AR-200S. For details, see the tables below.
Card Audio Recording Time Chart
PM-128-CF
(128MB)
RDAC-Mode
H-LINEAR
LINEAR MODE3 MODE2* MODE1
RDAC-
Grade
S-HIGH 15:08 22:43 1:00:35 1:00:35 1:30:53
HIGH 16:28 24:43 1:05:55 1:05:55 1:38:53
STANDARD 22:43 34:05 1:30:53 1:30:53 2:16:20
LONG1 32:57 49:26 2:11:51 2:11:51 3:17:47
LONG2 45:26 1:08:10 3:01:47 3:01:47 4:32:41
ANNOUNCE 1:30:53 2:16:20 6:03:35 6:03:35 9:05:22
Recorded Phrase Data
Phrase
settings
Playback Volume
100
Delay Time 00s00f
Playback Point Start: 00h00m00s00f0sf
End: The real time of the phrase
Repeat Playback OFF
Loop Playback OFF
Fade Fade In: OFF
Fade Out: OFF
Control Output OFF
MIDI Playback Tempo 120
Phrase Name MESSAGE 1
(MESSAGE + Phrase number)
AR-3000 Settings That Can Be Used
Phrase Compatibility
RDAC-Grade
ANNOUNCE o
LONG2 o
LONG1 o
STANDARD o
HIGH o
S-HIGH o
RDAC-Mode MODE1 o
MODE2 o
MODE3 o
LINEAR o
H-LINEAR o
Recording Type Stereo o
Mono o
1. Phrase messages
1.1
Playback Volume o
1.2 Delay Time o
1.3 Playback Point o
1.4 Repeat Playback o
1.5 Loop Playback o
1.6 Fade o
1.7 Control Output o
1.8 MIDI Playback Tempo o (*1)
1.9 Phrase Name o (*2)
2. Phrase Combination
2.1
Pattern Phrase o (*3)
2.2 Song Phrase o (*3)
4. Card Edit
4.1
Card Format (Number of Recorded Phrases) o
4.5 Card Protect o
4.6 Card Name o (*4)
5. Control Input Settings (*5)
5.1
Control Input Mode o
5.2 Direct Playback Method o
5.3 Program Playback Method o
5.4 Binary Playback Method o (*6)
5.5 Terminal Rec Method o
6. MIDI Settings
All MIDI Settings
x
7. RS-232C Setting
7.1 Data Transmission Speed Setting o
8. AR-LINK Setting
8.1
AR-LINK Mode x
9. System Settings
9.1
Dual Mono Mode o
9.2 Line Thru Settings o
9.3 EQ o
9.4 Volume Thru x
9.5 Busy Out o
9.6 Display Extinguished x
*1: MIDI phrases are played back silently for the duration of the phrase in
accordance with the playback tempo.
*2: The phrase name will not be displayed on the AR-200S.
*3: If a MIDI phrase is set, playback is silent for the duration of that phrase.
*4: The card name will not be displayed on the AR-200S.
*5: Enabled only when the playback mode is set to “Playback by Card Data.”
*6: For binary playback, up to 250 phrases can be played back.
AR-200S_e.book 21 ページ ２００５年１２月８日 木曜日 午前９時３分