Filter
Top Products
This section describes the various controls and features of
the Punch amplifiers.
Top View of Amplifier and End Caps
6
CONTROLS AND FEATURES
Punch
Housing
The cast aluminum heatsink of the Punch is designed for
high performance cooling. The raised design of the hous-
ing allows cables and wires to run underneath the unit.
This provides for greater wiring flexibility and protects the
cables from damage caused by excessive heat and bend-
ing.
Interchangeable end caps conceal the wiring and input
cables, giving the amplifier a clean, "stealth" look. Also
incorporated, is a holding dimple built into the end cap.
This small feature enables the cap to be held in place while
being mounted.
The end caps are secured to the housing with flush
mounting, captive screws.
Four (4) custom, round, hex screws included in the acces-
sory pack hold the unit in place. These screws are covered
when the end caps are installed.
End Caps
Mounting
Screws