Filter
Top Products
4. Cover the crimped area with the protective boot that
is supplied with the fuse holder.
5. Repeat the above steps to connect the remainder of
the red power wire to the other side of the fuse holder
and route to the amplifier mounting location.
Wiring the Power Connectors
1. Strip back approximately 3/8" (.95cm) of wire.
2. Insert the bared wire into the connector and crimp in
place as shown in the following diagram.
The gold B+ terminal must be connected
directly
to the
positive (+) terminal of the battery with an appropriate
size fuse. (See the Specifications Table for more infor-
mation.) This provides a power source with a low voltage
drop and low noise. Be sure to use the supplied fuse
and fuse holder within 18" (45.72cm) of the battery’s
positive terminal. Failure to do so may cause damage
to the vehicle and the amplifier.
If the power wire must be extended beyond 17' (518.16cm),
we recommend you use 8 gauge, or heavier, stranded
wire.
12
Power
3/8"
(.95cm)
Crimp Here
{
{
Crimp Here
Wire w/insulation
Bare
Wire
Connectors