Filter
Top Products
13
8. Slide the stereo into the sleeve until
it locks into place.
If you are securing the stereo in an
existing mounting hole in the dash,
push the mounting bolt covered with
the rubber mounting grommet
through the existing mounting hole
and make sure it is secure.
Note:
If the mounting bolt is too
short to reach the mounting hole,
remove the rubber mounting grom-
met and screw the supplied mount-
ing bolt extender onto the mounting
bolt. Then push the rubber grommet
onto the end of the bolt extender.
Otherwise, you can remove the rub-
ber mounting grommet and use the
extender and the supplied nut and
washer to attach the supplied metal
strap to the mounting bolt on the
back of the stereo. If necessary,
bend the metal strap to fit your vehi-
cle’s mounting area. Then use the
supplied sheet metal screw to attach
another section of the strap to a
solid metal part of the vehicle under
the dashboard. This strap also helps
ensure proper electrical grounding
of the stereo.
9. Snap the plastic collar onto the front
of the stereo.
10. Install your stereo’s control panel
(see “Replacing the Control Panel”
on Page 15).
Grommet
Grommet
Mounting Bolt Extender
12-2115a.fm Page 13 Wednesday, January 12, 2000 11:18 AM