Filter
Top Products
ADDITIONAL SAFETY INSTRUCTIONS
• To ensure maximum performance, please read this manual carefully. Keep it in a safe place for
future reference
• Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of
excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers,
motors). To prevent fire or electrical shock, do not expose the unit to rain or water
• Never remove the unit cover. Contact your dealer if an object falls inside the unit
• Do not use force on switches, controls or connection wires. When moving the unit, first
disconnect the power plug and the wires connected to other equipment. Never pull on the
wires themselves
• The openings on the unit cover assure proper ventilation of the unit. If these openings are
obstructed, the temperature inside the unit will rise rapidly. Therefore, avoid placing objects
against these openings, and install the unit in a well-ventilated area to prevent fire and damage
• Be sure to allow a space of at least 30 cm behind, 20 cm on both sides and 10 cm above the
top panel of the unit to prevent fire and damage
• Digital signals generated by this unit may interfere with other equipment such as tuners,
receivers or TVs. Move this unit further away from such equipment if interference is observed
• Do not attempt to clean the unit with chemical solvents; this might damage the finish. Use a
clean, dry cloth
• Be sure to read Section 8: Troubleshooting regarding common operating errors before
concluding that the unit is faulty
• When not planning to use this unit for long periods of time, disconnect the AC power plug from
the wall outlet
• To prevent lightning damage, disconnect the AC power plug when there is an electrical storm
• Grounding or polarization - Precautions should be taken so that the grounding or polarization
of an appliance is not defeated
• This unit is not disconnected from the AC power source as long as it is connected to the wall
outlet, even if this unit itself is turned off. This state is called the standby mode. In this mode,
this unit is designed to consume a small amount of power
3