Filter
Top Products
10
Application Operations (Continued)
4 Select the type of data to be received, then select “OK”.
Select “Reverb” to receive the data for the room’s reverb characteristics, and “MCACC Parameters” to
receive the data for the various MCACC parameters (measurements results). The “Group Delay” function
is not used on this receiver. Nothing is displayed if “Group Delay” is selected.
Data transmission starts.
When reception finishes the received data appear.
• The data used to display the reverberation characteristics graph (Reverb) and the MCACC parameters
are not deleted even when the receiver’s power is turned off. However, for the data used to display the
reverberation characteristics graph (Reverb), the data stored in the receiver is overwritten when the
reverberations are measured again. If you wish to display graphs of multiple sets of data, use the data
transfer function to store the data on a computer each time you measure the reverberations.
• In order to avoid malfunction, after the completion of the data transmission, unplug the RS-232C cable
connecting your PC and the receiver.
Note
Type of data
Continue