Filter
Top Products
02
02
Connecting your equipment
17
En
English
Français
Español
• For instructions on playing the iPod, see Playing an iPod on
page 19
.
Note
• When the ARC function is ON and the receiver is
connected to a compatible TV with an HDMI cable, and
you switch the input of the TV when the receiver’s
selection is iPod/USB input, the receiver may
automatically switch to TV. If this happens, switch the
receiver's input back to the original input, or turn OFF the
ARC function (see The HDMI Setup menu on page 30).
Connecting a USB device
It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
1 Switch the receiver into standby then connect your USB
device to the iPod/iPhone terminal on the front panel of
this receiver.
• This receiver does not support a USB hub.
• For instructions on playing the USB device, see Playing a
USB device on page 20.
Plugging in the receiver
Only plug in after you have connected all your components to
this receiver, including the speakers.
1 Plug the AC power cord into a convenient AC power
outlet.
CAUTION
• Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power cord
when your hands are wet as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords.
The power cords should be routed such that they are not
likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power
cord once in a while. When you find it damaged, ask your
nearest PIONEER authorized service center or your dealer
for a replacement.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g., when on vacation.
Note
• After this receiver is connected to an AC outlet, a 2
second to 10 second HDMI initialization process begins.
You cannot carry out any operations during this process.
The HDMI indicator in the front panel display blinks
during this process, and you can turn on this receiver
once it has stopped blinking. When you set ARC at HDMI
setup to OFF, you can skip this process. For details, see
The HDMI Setup menu on page 30.
AV RECEIVER
MASTER
VOLUME
ET ENTER
iPod iPhone
VSX
-324
HDMI
5V 1A
USB cable that comes
with the iPod
This receiver
iPod/iPhone
AV RECEIVER
MASTER
VOLUME
E
TENTER
iPod iPhone
VSX
-324
HDMI
5V 1A
USB mass
storage device
This receiver
VSX-324-K-P_CMXESM.book 17 ページ ２０１３年２月１３日 水曜日 午前９時１７分