Filter
Top Products
Additional information
12
96
En
Important information regarding the HDMI connection
There are cases where you may not be able to route HDMI signals through this receiver (this depends on the HDMI-
equipped component you are connecting–check with the manufacturer for HDMI compatibility information).
If you aren’t receiving HDMI signals properly through this r eceiver (from your component), please try one of the
following configurations when connecting up.
Configuration A
Use component video cables to connect the video output
of your HDMI-equipped component to the receiver’s
component video input. The receiver can then convert the
analog component video signal to a digital HDMI signal
for transmission to the display. For this configuration,
use the most convenient connection (digital is
recommended) for sending audio to the receiver. See the
operating instructions for more on audio connections.
Note
•The picture quality will change slightly during
conversion.
Configuration B
Connect your HDMI-equipped component directly to the
display using an HDMI cable. Then use the most
convenient connection (digital is recommended) for
sending audio to the receiver. See the operating
instructions for more on audio connections. Set the
display volume to minimum when using this
configuration.
Note
•If your display only has one HDMI terminal, you can
only receive HDMI video from the connected
component.
•Depending on the component, audio output may be
limited to the number of channels available from the
connected display unit (for example audio output is
reduced to 2 channels for a monitor with stereo audio
limitations).
• If you want to switch the input function, you’ll have to
switch functions on both the receiver and your
display unit.
• Since the sound is muted on the display when using
the HDMI connection, you must adjust the volume on
the displa
y every time you switch input functions.
USB interface
Synchronized operation not
possible using Control with
HDMI function.
• Check the HDMI connections.
• The cable may be damaged.
• Select ON for the Control with HDMI setting (see HDMI Setup on page 56).
• Select ALL for the Control Mode with HDMI setting (see HDMI Setup on page 56).
• Turn the TV’s power on before turning on this receiver’s power.
• Set the TV side Control with HDMI setting to ON (see TV’s operating instructions).
• VSX-1325 only: Connect the TV to the HDMI OUT 1 terminal and set the HDMI output to HDMI OUT
1. Then turn on first the TV’s power, then this receiver’s power.
Symptom Remedy
Symptoms Causes Remedies
The folders/files stored on a
USB memory device are not
displayed.
The folders/files are currently stored in a region
other than the FAT (File Allocation Table) region.
Store the folders/files in the FAT region.
The number of levels in a folder is more than 8. Limit the maximum number of levels in a folder to
8 (page 43).
There are more than 30 000 folders/files stored in
a USB memory device.
Limit the maximum number of folders/files stored
in a USB memory device to 30 000 (page 43).
The audio files are copyrighted. Copyrighted audio files stored on a USB memory
device cannot be played back (page 43).
VSX-1325_UXJCB.book 96 ページ ２０１０年３月９日 火曜日 午後３時４分