Filter
Top Products
Additional information07
28
En
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the
STANDBY/ON
button
for about three seconds.
3 When you see RESET? appear in the
display, press the
ENTER
button.
OK?
shows in the display.
4 Press
SETUP
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory default
setting.
Cleaning the unit
• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser
diluted five or six times with water, and
wrung out well, and then wipe again with a
dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.
No sound from surround or
center speakers.
• Connect the speakers properly.
• Refer to
Channel level
on page 23 to check the speaker levels.
No sound from subwoofer. • The Dolby Digital or DTS source you are listening to may not have an
LFE channel.
• Switch the
LFE Attenuator Setup
on page 24 to
LFEATT 0
or
LFEATT 10
.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back.
• Set the digital volume level of the player to full, or to the neutral
position.
During a playback search,
noise is output from a DTS
compatible CD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control.
• Replace the batteries (refer to page 5).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer
to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press
DIMMER
on the remote control repeatedly to return to the
default.
Problem
Remedy
SX_316.book Page 28 Tuesday, March 7, 2006 12:01 PM