Filter
Top Products
Additional information
07
27
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 7:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Take a look at the other
components and electrical appliances being used, because sometimes the problem may lie there.
If the trouble isn't sorted out even after going through the checks below, ask your nearest Pioneer
authorized independent service company to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity,
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
Remedy
The power does not turn on. • Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
No sound is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting
up
on page 7).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the
MASTER VOLUME
.
Considerable noise in radio
broadcasts.
• Tune in the correct frequency.
• Connect the antenna and adjust the direction and position for best
reception(refer to page 9).
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 10).
• Connect an additional internal or external AM antenna (refer to
page 10).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Move antennas farther away from equipment causing the noise.
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 10).
SX_316.book Page 27 Tuesday, March 7, 2006 12:01 PM