Filter
Top Products
36
<ARB7192>
Recording from Audio Components
The following operations show you how to record audio to the cassette, DAT, or MD deck connected to the MD/TAPE 1
or TAPE 2 MONITOR jacks.
1
Select the component you want to record.
Be sure to press SIGNAL SELECT on the front panel to choose
“ANALOG”. (Refer to “Switching ANALOG/DIGITAL signal input” on
page 26.)
2
Prepare the program source.
(Tune in the radio station or load the CD, etc.)
3
Insert a blank tape into the cassette deck (MD/TAPE 1 or
TAPE 2 MONITOR) and adjust the recording level (if necessary).
4
Start recording on the cassette deck, then start playback
from the source component.
Record monitor (TAPE 2 MONITOR)
If you connect a cassette deck (etc.) with a record monitor function to the
TAPE 2 MONITOR jacks, you can listen to the sound of the recording as it is
being recorded.
Press TAPE 2 MONITOR to switch between the sound of the
recording (TAPE 2 indicator on) and the sound of the source
component (TAPE 2 indicator off).
1
TAPE 2
MONITOR
SIGNAL SELECT
The receiver’s volume, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect on the
recorded signal.
memo
• This receiver outputs the input signal directly to the recording
device. As there is no conversion of the audio signal,
recordings cannot be made from analog to digital, and similarly
from digital to analog.
• The MD/TAPE 1 function is not able to record the TAPE 2
MONITOR.
memo
AV MULTI-CHANNEL RECEIVER
REMOTE CONTROL UNIT
RECEIVER
STANDBY/ON
LD
DVD
TUNER MPX
STANDBY/ON
CLASS
DIRECT
.ACCESS
TAPE
TV FUNC.
BAND
CD
SOURCE
SELECT
TEST TONE
EFFECT
SURROUND
DSP MODE
TV VOL.
FREQ.
0
9
5
13
MUTING
MASTER
VOLUME
Î
CD DISC
CHANNEL
STATION
TV
CONTROL
LEVEL
FUNCTION
CHANNEL
SELECT
ATT.
6
2
4
87
1
Other Operations