Filter
Top Products
15
<ARB7192>
SET UP
Preparations
1
Press RECEIVER STANDBY/ON to turn the power on.
The STANDBY indicator goes out.
2
Press SURROUND.
This switches the remote to the surround setup mode.
3
Press @ or # to select the mode you desire.
For best results, start with “SPEAKER setting mode” and make your
initial adjustments in the order described below.
The current settings are displayed automatically.
SPEAKER (Front, Center, Surround) setting mode (page 16)
Use to specify the type of speakers you have connected.
SUB WOOFER ON/OFF setting mode (page 17)
Use to specify the sub woofer as on or off.
Crossover frequency setting mode (page 17)
Use to determine which frequencies will be sent to the sub woofer or
“Large” speakers.
LFE attenuator setting mode (page 17)
Use to specify the peak level for the LFE channel and the crossover
network for rerouted bass frequencies.
Low cut filter ON/OFF setting mode (page 18)
Use to cut the distorted sound from the sub woofer.
FRONT speaker distance setting mode (page 18)
Use to specify the distance from your listening position to your front speaker.
CENTER speaker distance setting mode (page 18)
Use to specify the distance from your listening position to your center speaker.
SURROUND speaker distance time setting mode (page 18)
Use to specify the distance from your listening position to your surround speakers.
Dynamic range control setting mode (page 19)
Use to compress the dynamic range of the sound track.
Coaxial digital input setting (page 19)
Use to specify the input to be assigned to the coaxial digital input.
Optical digital input 1 setting (page 19)
Use to specify the input to be assigned to the optical digital input 1.
Optical digital input 2 setting (page 19)
Use to specify the input to be assigned to the optical digital input 2.
4
Press % or fi to select the setting you desire.
The setting is entered automatically.
5
Repeat steps 3 and 4 to set other surround modes.
Setting Up for Surround Sound
Be sure to switch the power of this unit on (The STANDBY indicator goes out) before operating.
To ensure the best possible surround sound, be sure to complete the following set up operations. This is particularly
important when using the
(Dolby) Surround mode. You only need to make these settings once (unless you change
the placement of your current speaker system or add new speakers, etc.). Refer to the following pages for detailed
descriptions of the settings available for each mode.
1
2
4
• The setting mode is automatically exited
if no operation is performed for 20
seconds.
memo
3
AV MULTI-CHANNEL RECEIVER
REMOTE CONTROL UNIT
RECEIVER
STANDBY/ON
LD
DVD
TUNER MPX
STANDBY/ON
CLASS
DIRECT
.ACCESS
TAPE
TV FUNC.
BAND
CD
SOURCE
SELECT
TEST TONE
EFFECT
SURROUND
DSP MODE
TV VOL.
FREQ.
0
79
5
13
MUTING
MASTER
VOLUME
Î
CD DISC
CHANNEL
STATION
TV
CONTROL
LEVEL
FUNCTION
CHANNEL
SELECT
ATT.
6
2
4
8