Filter
Top Products
26
<ARB7192>
Switching ANALOG/DIGITAL Signal Input
The input of the component set in the digital input setting (refer to page 19) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
1
Press SIGNAL SELECT on the front panel to select the
input signal corresponding to the source component.
Each press switches between ANALOG and DIGITAL signal selection.
2
memo
SIGNAL SELECT
Sound Modes
SP
SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
ANALOG
A
SP
SIGNAL
SELECT
DIGITAL
SIGNAL
SELECT
DIGITAL
A
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input.
When a Dolgy Digital signal is input.
SP
SIGNAL
SELECT
DIGITAL
AC-3
SIGNAL
SELECT
DIGITAL
AC-3
A
• SIGNAL SELECT is fixed in the “ANALOG” position for components not
assigned to one of the three digital input jacks.
• Because the audio from a karaoke microphone and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to “ANALOG”.
• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and
48kHz), digital signal formats. With digital signal formats other than these,
set SIGNAL SELECT to “ANALOG”.