Filter
Top Products
9
2 Connecting Up
En
LINE
IN
OPTICAL
IN
REC
OUT
PLAY
L
R
DIGITAL
OUT
COAXIAL
OPTICAL
DIGITAL
IN
COAXIAL
CONTROL AC IN
Rear panel
Important: Before making or changing any rear panel
connections, make sure that all the components are switched off
and unplugged from the power supply.
Connecting optical cords
Before plugging in an optical cord, pull
out the protective cover from the
optical jack.
Optical interconnects only plug in one
way, so make sure the plug is correctly
lined up with the jack before inserting.
You should hear it click into position
when fully inserted.
Avoid using optical interconnects
longer than 3 meters. Optical
interconnects are available from any
good audio dealer.
Connecting coaxial cords
Use a regular interconnect with a pin-
type (also called RCA or phono) plug
on each end to connect components
with digital coaxial-type jacks. These
are available from any good audio
dealer. Make sure that the plug is
pushed fully home.
COAXIAL
LINE
OPTICAL
Connecting stereo audio cords
The two sets of stereo audio cords
supplied connect this unit to your
amplifier/receiver’s analog line
inputs/outputs. Be sure to fully insert
each plug for the best connection.
The plugs and jacks are color-coded
to make connection easier.
Connecting the control cord
Use a stereo miniplug cord (not
supplied) to connect the CONTROL
OUT
of your Pioneer amplifier or
receiver to the CONTROL IN of this
unit. If you plan to use this feature,
you must also connect the analog
audio LINE IN/OUTs.
Plugging in
After double-checking all the connections, connect the power cord
to this unit and plug the other end into a standard wall outlet.
Congratulations! You’re done setting up.
After completing all other
connections, connect the
power cord and plug into a
standard AC wall outlet.
Connect to the CONTROL
OUT of a Pioneer amplifer or
receiver to be able to use the
amp/receiver's remote control
with this unit.
Connect to the OPTICAL IN or
COAXIAL IN of a CD-R,
MiniDisc or DAT recorder, or
other digital recording device to
be able to record from this unit.
Connect to the TAPE/MD/
CD-R LINE IN/OUT jacks
of your amplifier or receiver.
Connect to the OPTICAL OUT
or COAXIAL OUT of a CD,
MiniDisc, DAT or other digital
equipment for digital recording.