Filter
Top Products
6
1 Before You Start
En
Hints on installation
We want you to enjoy using this unit for years to come, so please
bear in mind the following points when choosing a suitable
location for it:
Do...
✓ Use in a well-ventilated room.
✓ Place on a solid, flat, level surface, such as a table, shelf or
stereo rack.
Don’t...
✗ Use in a place exposed to high temperatures or humidity,
including near radiators and other heat-generating
appliances.
✗ Place on a window sill or other place where the player will
be exposed to direct sunlight.
✗ Use in an excessively dusty or damp environment.
✗ Place directly on top of an amplifier, or other component in
your stereo system that becomes hot in use.
✗ Use near a television or monitor as you may experience
interference—especially if the television uses an indoor
antenna.
✗ Use in a kitchen or other room where the player may be
exposed to smoke or steam.
✗ Use on a thick rug or carpet, or cover with cloth—this may
prevent proper cooling of the unit.
✗ Place on an unstable surface, or one that is not large
enough to support all four of the unit’s feet.
Checking what's in the box
Thank you for buying this Pioneer product. Before starting to set up
your new CD recorder, please check that you have received the
following supplied accessories:
• Stereo audio cords (x2) • AC power cord*
• Two 'AA' size R6P batteries • Remote control unit
• Warranty card
• These operating instructions
* UK model only: the AC power cord is located in the spacer
box.
Using this manual
This manual is for the PDR–W839 Compact Disc Recorder/Multi-
CD Changer. It is split into two sections; the first covers setting up,
and the second, using the recorder. Set up, which starts here, shows
you how to install and connect up the recorder to the rest of your
system.
In the second section of the manual, starting on page 11, you'll
learn how to use the various features of the recorder. The final part
of the manual provides a list of display messages, a troubleshooting
section, and technical specifications.
Putting the batteries in the remote
1 Turn over the remote
control, then press and
slide the battery
compartment cover off.
2 Put in the batteries
supplied, taking care to
match the plus and
minus ends of each
battery with the
markings inside the
compartment.
3 Slide the cover back on, and your remote is ready for use.
Caution!
Incorrect use of batteries can result in hazards such as leakage and
bursting. Please observe the following:
• Don’t mix new and old batteries together
• Don’t use different kinds of battery together—although they may
look similar, different batteries may have different voltages.
• Make sure that the plus and minus ends of each battery
match the indications in the battery compartment.
• Remove batteries from equipment that isn’t going to be used
for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
institution’s rules that apply in your country or area.
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles between the remote
and the remote sensor on the unit.
• Use within the operating range and angle, as shown right.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit’s
remote sensor.
• Remote controllers for different devices can interfere with
each other. Avoid using remotes for other equipment
located close to this unit.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
30
30
7m (23ft.)