Filter
Top Products
24
6 Finalizing and Erasing
Clearing skip IDs:
1 With the recorder stopped, press
SKIP.
The display indicates that you’re in skip set/clear mode and
playback starts.
DISC
DISC
DISC
ALL
FADER
OVER
ANA
TRK MIN SEC
CD-R
1
2
3
X1
L
R
–dB
8
40
18 6 0
2 Use the 4 and ¢ buttons to
select the track you want to clear
the skip ID for.
The SKIP indicator lights if the track playing is marked
with a skip ID.
3 Press SKIP CLEAR.
The SKIP indicator starts to blink.
DISC
DISC
DISC
ALL
FADER
SKIP
OVER
ANA
TRK
CD-R
1
2
3
X1
L
R
–dB
8
40
18 6 0
• If the track you selected in step 2 above didn’t have a skip ID
set, playback jumps to the next track that does.
• Use the 4 and ¢ buttons if you want to change the
track again here.
• If there's no room left on the disc to clear a skip ID, the
display will show the message SKIP FULL.
COMPACT DISC RECORDER/
MULTI-CD CHANGER
SKIP
SKIP
CLEAR
REMOTE CONTROL UNIT
&#
$›
Î
OPEN/CLOSE
REC/
REC MUTE
3
- COMPACT DISC MULTI CHANGER
4 1
¡ ¢
7
COMPACT DISC DIGITAL RECORDER
0
◊ÛB¿ˆ≥≤/
COMPACT DISC RECORDER / MULTI-CD CHANGER
CD-R CONTROL
4 Press SKIP CLEAR again to clear the
skip ID for the track playing.
The SKIP indicator disappears once the skip ID has been
cleared.
• To cancel, press 7.
5 Clear further skip IDs by repeating
steps 2 to 4.
6 When you're finished, press 7 to stop
the disc and press 0 (CD-R side).
Until you eject the disc, the recorder stores the skip ID
information in its memory. On pressing 0, the recorder
writes the skip ID information onto the disc.
Be careful: don’t switch off the unit before ejecting the
disc—you’ll lose this sessions skip ID changes!