Filter
Top Products
# You can scroll the name and phone number
by pressing and holding DISPLAY.
# If you do not operate anything within about 30
seconds, the list display is canceled automati-
cally.
Calling a number from the Call History
1 Display the list and select a phone num-
ber.
Display the phone number you want to make a
call.
Refer to Displaying the Call History on the pre-
vious page.
2 Press MULTI-CONTROL to make a call.
While calling, the phone number is displayed.
# If the number is already in the Phone Book
then the name is also displayed.
3 To end the call, press PHONE.
The estimated call time appears in the display
(this may differ slightly from the actual call
time).
Calling an international number
from the Call History
When calling an international number stored
in the Call History, proceed the countr y code
with a +.
1 Display the phone number you want to
make an international call.
Refer to Calling an international number from
the Call History on this page.
2 Press and hold MULTI-CONTROL to add
+.
# To delete +, press and hold MULTI-CONTROL
again.
3 Press MULTI-CONTROL to make a call.
While calling, Dialling is flashing.
4 To end the call, press PHONE.
The estimated call time appears in the display
(this may differ slightly from the actual call
time).
Assigning preset numbers
Important
To perform this operation, be sure to park your ve-
hicle and apply the parking brake.
Numbers that you dial frequently can be as-
signed to presets for quick recall.
1 Select a desired phone number from
the Phone Book or the Call History.
To select a desired phone number from the
Phone Book or the Call Histor y, see the in-
structions explained in previous pages.
2 Press one of 0 to 9 on the remote con-
trol and hold until the beep sounds.
The selected phone number has been stored
in memory. The next time you press the same
preset button, the phone number is recalled
from memory.
Making a call by entering
phone number
Important
To perform this operation, be sure to park your ve-
hicle and apply the parking brake.
1 Use MULTI-CONTROL to select
Number dial in the function menu.
# You can also press DIRECT on the remote con-
trol to enter in this menu from the standby dis-
play.
2 Push MULTI-CONTROL up or down to
select a number.
# You can also input numbers by pressing 0 to 9
on the remote control.
3 Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
# Up to 24 digits can be entered.
4 When you completed entering the
number, press MULTI-CONTROL.
Operating this unit
En
41
English
Section
02