Filter
Top Products
Controlling the rest of your system 09
49
En
English
Français
Deutsch
Nederlands
Italiano
Español
3 Press and hold
ENTER for about two
seconds
.
The LCD shows OK to confirm the remote
presets have been erased.
Direct function
•Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component you
select (using the MULTI CONTROL buttons)
will be selected by both the receiver and the
remote control. When you turn direct function
off, you can operate the remote control without
affecting the receiver.
1
1 While pressing the RECEIVER button,
press and hold the
SETUP
button.
The remote LCD display shows SETUP.
2Use
/
to select
DIRECT F
then press
ENTER
.
3 Press the MULTI CONTROL button for the
component you want to control
then press
ENTER
.
The LCD on the remote displays the
component you want to control.
4Use
/
to switch direct function ON or
OFF then press
ENTER
.
The LCD shows OK to confirm the setting.
Confirming preset codes
Use this feature to check which preset code is
assigned to a MULTI CONTROL button.
1 While pressing the RECEIVER button,
press and hold the
SETUP
button.
The remote LCD display shows SETUP.
2Use
/
to select READ ID then press
ENTER
.
3 Press the MULTI CONTROL button of the
component for which you want to check the
preset code.
The brand name and preset code appears in
the display for three seconds.
Note
1 You can’t use direct function with the TV CTRL function.
VSX_917.book.fm Page 49 Thursday, December 7, 2006 4:40 PM