Filter
Top Products
Controlling the rest of your system09
48
En
Selecting preset codes directly
1 While pressing the RECEIVER button,
press and hold the
SETUP
button.
The remote LCD display shows SETUP.
2Use
/
to select PRESET then press
ENTER
.
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER
.
The LCD on the remote displays the
component you want to control.
1
4Use
/
to select the first letter of the
brand name of your component then press
ENTER
.
This should be the manufacturer’s name (for
example, P for Pioneer).
5Use
/
to select the manufacturer’s
name from the list then press
ENTER
.
6Use
/
to select the proper code from
the list, then try using this remote control
with your component.
The code should start with the component type
(for example, DVD 009). If there is more than
one, start with the first one.
To try out the remote control, switch the
component on or off (into standby) by pressing
SOURCE . If it doesn’t seem to work, select
the next code from the list (if there is one).
7 If your component is controlled
successfully, press
ENTER
to confirm.
The remote LCD display shows OK.
Erasing one of the remote
control button settings
This erases a control assigned to one of the
buttons and restores it to the factory default.
1 While pressing the RECEIVER button,
press and hold the
SETUP
button.
The remote LCD display shows SETUP.
2Use
/
to select
ERASE
then press
ENTER
.
3 Press the MULTI CONTROL button
corresponding to the button setting to be
erased then press
ENTER
.
The LCD on the remote displays the
component.
4 Press and hold the button to be erased for
two seconds.
The LCD display shows OK or NO CODE to
confirm the button has been erased.
5 Repeat step 4 to erase other buttons.
6 Press the RECEIVER button when you’re
done.
Erasing all of the remote control
presets
This will erase all preset remote control preset
codes.
1 While pressing the RECEIVER button,
press and hold the
SETUP
button.
The remote LCD display shows SETUP.
2Use
/
to select
RESET
then press
ENTER
.
Note
1 You can’t assign the RECEIVER button.
ANALOG
AT T
SB ch
SLEEP
RECEIVER
SOURCE
INPUT
SELECT
TV DVR
TV CTRL
CD
RECEIVER
AMFM
DVD
XM RADIO
SIRIUS
CD-R/TAPE
F.AUDIO
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
MIDNIGHT
DIMMER
SR+
+10
D.ACCESS
SIGNAL SEL
CLASS
DISC
TV CONTROL
VOL
TUNE
TUNE
INPUT
SELECT
TV CH
TV VOL
ENTER
TOP MENU
CATEGORY
T.EDIT
DTV MENU
MENU
RETURN
GUIDE
SETUP
ENTER
ST ST
VSX_917.book.fm Page 48 Thursday, December 7, 2006 4:40 PM