Filter
Top Products
Phoenix Gold iSeries
www.PHOENIXGOLD.com
8
5. Digital Controller Instructions
Step 1 - Using the plastic pry tool remove the trim strip above the radio (Fig A & B).
Step 2 - With the trim strip removed, route the wire from the digital controller to the iSeries harness
(being careful to not have the wire pinched by any factory clips that reattach the trim strip) located at
the factory radio location and connect to the 5 pin plug near the 44 pin T-harness (Fig C).
Step 3 - Reinstall the trim strip leaving just enough slack on the digital controller to mount on the
outside of the trim strip.
Step 4 - Using the supplied two sided tape, secure the digital controller to the factory trim
strip (Fig D).
Fig. A
Fig. C
Fig. B
Fig. D