Filter
Top Products
Phoenix Gold iSeries
www.PHOENIXGOLD.com
4
Fig. D
3. Accessing the Battery and Factory Amplier
(If equipped)
Fig. A Fig. B Fig. C
Fig. G
Fig. E
Fig. H Fig. I
Fig. F
Step 1 - Remove the trunk oor liner (Fig. A) and unscrew the spare tire cover fastener (Fig. B).
Remove the spare tire cover. Remove either the spare tire (if equipped), or the molded foam tire
ination kit (Fig C). This will give you access to the battery location.
** If the vehicle is equipped with a factory amplier continue to step 2. If not equipped with a factory amplier
please skip to step 6
Step 2 - Remove the (6) cargo net holders in the rear of the trunk by unscrewing them (Fig D).
Remove the rear plastic panel by pulling it up and out (towards the front of the vehicle) (Fig E).
Step 3
- There is a plastic push clip located on the upper section of the left (drivers side) carpet
panel (Fig G) and a threaded plastic washer on the lower section that needs to be removed (Fig H).
Pull back the carpet on the left (drivers side) of the trunk to gain access to the stock amplier which
is located on the back wall of the trunk (near the bumper) (Fig I & J).