Filter
Top Products
Phoenix Gold iSeries
www.PHOENIXGOLD.com
9
6. Routing the iSeries Signal Harness
Step 1 - Route the iSeries T-harness behind the radio and under the steering wheel (Fig A) along
the factory harness making sure the wires will not get pinched and do not interfere with the steering
wheel operation. Secure to the factory harness and brackets with the supplied wire ties. Removal of
the A/C vent is recommended. There are 2 bolts to be removed (1) 7mm and (1) T-20 (Fig B).
Step 2 - Remove the driver’s door sill, kick panel, and left side dash panel (Fig C & D). Route the
iSeries harness to the rear of the car from the factory radio securing it to the factory harness along
the way with the supplied wire ties (Fig E).
Step 3 - Remove the lower section of the rear seat by lifting up on it to release the factory clips
(Fig F & G). Continue to route the wires from the front of the vehicle to the trunk. PLEASE NOTE: Be
sure to keep the iSeries wire harness away from the factory power lead for the battery (Fig H). Once
the iSeries harness has been routed to the trunk connect it to the iSeries amplier. ***If vehicle is
not equipped with a factory amplier the short 2 foot adaptor harness will plug into the
harness coming from the factory radio***
Fig. A Fig. B
Fig. C Fig. D Fig. E
Fig. F Fig. G Fig. H