Filter
Top Products
Phoenix Gold iSeries
www.PHOENIXGOLD.com
5
Step 4 - Unplug the (3) factory amplier plugs from the factory amplier (Fig K). Remove the factory
harness from the fastening points (Fig L). This harness will need to be rerouted back toward the rear
of the back seat to allow connection to the iSeries factory integration harness (Fig M). In the iSeries
factory integration harness you will locate a 2 foot long harness that has a 12-pin white Molex
connector on one end and a 16-pin green adaptor plug on the other end (Fig N). Plug in the green
16 pin iSeries adaptor plug to the factory harness that was routed towards the front of the vehicle.
Please note that only one of the factory plugs will be used for this application.
Step 5
- Reinstall the carpet leaving the harness that you connected in step 4 exposed so that you
can easily plug it into the iSeries amplier (Fig O). This harness will plug into the iSeries amplier on
the front side (located closest to the rear seat). Re-install the rear plastic panel using the (6) cargo
net holders you removed in Step 2 (Fig P).
Fig. M
Fig. J Fig. K Fig. L
Fig. N
Fig. PFig. O