Filter
Top Products
Phoenix Gold iSeries
www.PHOENIXGOLD.com
6
Step 6 - Connect the supplied iSeries power harness to the 12 volt and ground connection points
on the iSeries amplier (Fig Q). Route the supplied iSeries power harness toward the factory battery
location. On the right rear (passenger side) of the spare tire well you will see the factory grounding
point. Remove the factory bolt and connect the supplied iSeries ground wire along with the factory
ground (Fig R). Make sure to tighten securely. Unclip the positive battery cover to expose the
positive battery terminal. On the left (driver) side of the battery terminal remove the 10mm nut and
attach the positive lead from the supplied iSeries harness (Fig S). Re-attach the 10mm bolt and
tighten securely. Re-attach the positive battery cover.
Step 7
- Route the supplied iSeries power harness along the factory power and ground leads
for the battery and secure to the harness with the supplied wire ties (Fig T). Put the spare tire (if
equipped), or the molded foam ination system back into their original location (Fig U). Replace the
factory spare tire well cover and secure with the factory fastener. Re-install the carpet on the oor of
the trunk (Fig V & W).
Fig. Q Fig. S
Fig. T Fig. U
Fig. R
Fig. W
Fig. V