Filter
Top Products
22
English
3139 116 19161
CLOCK TIMER
Viewing the Clock
You can view the clock (if it is set) while
the system is in standby mode or any
source mode. It will be displayed for about
7 seconds.
• Press CLOCK/TIMER briefly
(on the
system only)
.
™ “10:38” (the current time) will be
displayed.
™ “--:--” will be displayed if the
clock is not set.
Setting the Clock
The clock is set in 24-hour mode, e.g.
“00:00“ or “23:59“. Before setting the
clock, you must be in the View Clock mode.
1 Press CLOCK/TIMER to select clock
mode.
™ “00:00” or the current time starts
flashing.
2 Press S or T to set the hour
(PRESET mode OFF)
.
3 Press S or T to set the minute
(PRESET mode ON)
.
4 Press CLOCK/TIMER again to store the
setting.
™ The clock starts.
• To exit without storing the setting, press
STOP on the system.
BACK
REC/CD SYN
PROG/A. REV
FLAT
PRESET
STOP
LOUDNESS
INCREDIBLE
SURROUND
TREBLEBASS
DOLBY B NR
CLOCK/
TIMER
3 CDC
TAPE
CDR/AUX
TUNER
DIGITAL STEREO HIFI SYSTEM
DUBBING
NORMAL•FAST
60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz
SOUND VOLUME
PRESET AM LWTRACK REPEAT MW FM STEREO PROGRAM TIMER SHUFFLE
SURROUND
INCREDIBLE
FLAT
LOUDNESS
CD CHANGER
T.A.
NEWS
SLEEP
DIM
REC
FRONT
HSD
DIM
PLAY
DIGITAL CONTROL
SEARCH/TUNE
PRESET
▲
▲
/
A•B
Notes:
– During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
– When a power interruption occurs, the
clock setting is erased.
– To set the time with RDS clock, see
"Receiving RDS Radio Station" under
TUNER section.
Setting the Timer
• The system can switch on to CD,
TUNER, or TAPE 2 mode automatically
at a preset time. It can serve as an
alarm to wake you up.
• Before setting the timer, make sure the
clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will start to
increase from the minimum level
until the volume level before the set
is switched to standby mode.
1 Press and hold CLOCK/TIMER for more
than 2 seconds to select timer mode.
™ “00:00” or the last set timer starts
flashing. The TIMER flag flashes.
™ The last selected source is lit while
other available sources are flashing.
2 Press 3 CDC, TUNER or TAPE to select
the desired source.
• Before selecting CD or TAPE, make sure
a CD or tape is loaded in the CD tray or
tape deck 2.
3 Press S or T to set the hour
for the timer to start
(PRESET mode
OFF)
.
4 Press S or T to set the minute
for the timer to start
(PRESET mode ON)
.
5 Press CLOCK/TIMER to store the start
time.
™ The timer is now set.
™ The TIMER flag remains on the display.