Filter
Top Products
21
English
3139 116 19161
RECORDING
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE to select tape deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
• Make sure the tape in tape deck 1 has
its full spool to the left.
3
(For Tape Deck 2 only)
Press SIDE on the remote control to
select the recording side.
4 Press DUBBING NORMAL•FAST
once
for normal speed dubbing or
twice
(within 2 seconds)
for high speed
dubbing.
™ “NORMAL” (normal speed) or
“FAST” (high speed) will be
displayed, followed by
“DUBBING”.
™ The HSD flag appears on the display
during high speed dubbing.
• Dubbing will start immediately.
™ The REC flag starts flashing.
5 Press STOP to stop dubbing.
Notes:
– Only
å å
å å
å
mode is available during
dubbing.
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
CD Synchro Start Recording
During CD synchro start recording,
• Do not fast forward/rewind your tape in
tape deck 1.
• Do not listen to another source.
1 Press TAPE to select tape deck 2.
• Load a blank tape into tape deck 2 with
the open side downward.
2 Press SIDE on remote control to select
the recording side.
3 Press A. REV to select the playback
mode (
å å
å å
å or ˙ ).
4 Press 3 CDC.
• You can program the tracks in the order
you want them to be recorded (see
Programming Tracks). If you do not, the
tracks are recorded according to the
order on the selected disc.
5 Press CD SYN to start recording.
™ The REC flag starts flashing.
6 Press STOP to stop recording CD
playback.
One Touch Recording
• For One Touch Recording, as soon as you
press REC, the current source (3 CDC,
TUNER or CDR/AUX) will be recorded on
tape deck 2
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
™ The REC flag starts flashing.
3 Press STOP to stop recording.
Note:
– When you press RECORD while in TAPE
mode, "
SELECT SOURCE
" will be
displayed. One Touch Recording is not
possible in TAPE mode.
Digital Recording via Digital
Out
For CD digital recording, please refer to the
Instructions Manual of the CD Recorder,
digital audio equipment, etc.