Philips FW-D1 Stereo System User Manual


 
3139 115 20054
7
English
Accessories
(Supplied)
Remote control
Batteries (two AA size) for remote
control
AM loop antenna
FM wire antenna
AC power cord
For model FW-D5 only
CS-05 speaker package (includes one
pair of surround speakers and one
centre speaker)
CVBS cable cinch
GENERAL INFORMATION SAFETY INFORMATION
Safety Information
Before operating the system, check that
the operating voltage indicated on the
typeplate (or the voltage indication
beside the voltage selector) of your
system is identical with the voltage of
your local power supply. If not, please
consult your dealer. The typeplate is
located at the rear of your system.
When the system is switched on, do not
move it around.
Place the system on a solid base (e.g. a
cabinet).
Place the system in a location with
adequate ventilation to prevent internal
heat build-up in your system. Allow at
least 10 cm (4 inches) clearance from
the rear and the top of the unit and 5 cm
(2 inches) from each side.
Do not place the system on soft carpet
that will cover the ventilation hole at
the bottom.
Do not expose the system to excessive
moisture, rain, sand or heat sources.
Under no circumstances should you
repair the system yourself, as this will
invalidate the warranty!
IMPORTANT:
PLEASE NOTE THAT THE
VOLTAGE SELECTOR
LOCATED AT THE REAR OF
THIS SYSTEM IS PRESET AT
220V FROM THE FACTORY.
FOR COUNTRIES THAT
OPERATE AT 110V, PLEASE
ADJUST TO 110V BEFORE YOU
SWITCH ON THE SYSTEM.
General Information
The typeplate (which contains the
serial number) is located at the rear
of the system.
Recording is permissible if
copyright or other rights of third
parties are not infringed.
Environmental Information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which
can be recycled and reused if disassembled
by a specialized company. Please observe
the local regulations regarding the disposal
of packaging materials, exhausted
batteries and old equipment.
If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the CD/DVD
unit inside the system. Should this
occur, the player will not operate
normally. Leave the power on for about
one hour with no disc in the system until
normal playback is possible.
Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.
To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.
pg 001-41/D5-D1/21-Eng new 6/8/01, 11:32 AM7