Filter
Top Products
AM Antenna Connection
The T 3 includes a separate molded plastic loop AM antenna with spade lugs at the
end of its two wires. With this antenna, you can receive AM stations in many urban
and suburban locations.
What You’ll Need:
• The supplied AM “loop” antenna
Before Connecting
Turn off the power to the T 3.
To Connect
Snap the loop antenna into the plastic holder at the far left side of the T 3 rear panel.
Loosen the GND and AM terminals on the T 3 rear panel. No screwdriver is needed.
Slide the spade lug from each antenna wire under each of these terminals.
Tighten these terminals so the spade lugs are firmly secured and not touching each other.
Position the loop antenna for best AM reception.
Once connected and clipped into its holder, you can swivel the antenna away from the T 3 rear
panel to optimize AM reception.
ANTENNA CONNECTIONS continued
5
1
2
3
4
5
AM LOOP ANTENNA
CLIP ON
AM LOOP ANTENNA
RS232 Control
Region
EU
US