Filter
Top Products
OPERATING YOUR T 3 continued
Browsing through Preset Stations from the Remote Control
Turn on the T 3 by pressing the On-Off button on the front panel or the On button on
its remote control.
Press the < Preset > button on the remote control.
Each time you press the large < button on the remote control you select a lower preset number.
Each time you press the large > button on the remote control you select a higher
preset number.
Selecting Preset Stations on the Front Panel
Turn on the T 3 by pressing the On-Off button on the front panel or the On button on
its remote control.
Press the < Select > button until < PRESET > appears in the front panel display.
Turn the round knob clockwise to select higher preset numbers.
Turn the round knob counter-clockwise to select lower preset numbers.
YOU SHOULD KNOW
Each time the T 3 is turned on, it will resume the same station and tuning method that were selected
before it was turned off. If you normally select stations with preset buttons, you won’t have to press
the < Select > button on the front panel or the < Preset > button on the remote control.
Remember, if you select a preset and the display shows 108 (FM) or 1720 (AM), there’s no station
saved to it.
Saving Stations as Presets - Auto Memory
Auto Memory is an easy way to save stations, but it doesn’t give you control over which
stations are saved. Auto Memory automatically looks for stations and saves the first 30
stations it finds as presets 1 – 30. It operates independently for the FM and AM bands.
Activating Auto Memory
Turn on the T 3 by pressing the On-Off button on the Front Panel or the On button on
its remote control.
Select the FM band with the AM-FM button on the front panel or remote control
Press and hold the Memory button on the front panel or the Mem button on the remote
control for over 3 seconds. AUTOMEM will appear in the display for three seconds. After
that, <MANUAL> appears in the front panel display during the Auto Memory process.
The T 3 will scan the entire FM band and start storing stations into preset memory
beginning with P 1.
This procedure will continue until 30 stations have been saved as presets.
Select AM and repeat to automatically save stations in the AM band.
YOU SHOULD KNOW
You can interrupt the Auto Memory process by pressing the FM-AM button on either the remote
or the front panel. You can also interrupt Auto Memory by turning off the T 3 from the remote
or front panel.
16
1
2
3
4
1
2
3
4
1
2
3
4
5
6
See page 18 for T 3 Front Panel and Remote Control layout