Filter
Top Products
OPERATING YOUR P 3 continued
Selecting the Input Source
You can select the input source by repeatedly pressing the Source button on the front
panel until the desired source name appears in the status display. You can also select
the desired source directly with the Source select buttons on the remote control.
The Source buttons on the remote control correspond to the following:
Remote Control Button Input
Direct 1
Direct 2
Aux (line or phono selected at rear panel)
Tuner
CD
Tape
Selecting the Input Source on the P 3
Press the front panel Source button until the desired input source is selected. You can
also press the Source buttons on the remote control.
Adjusting the Balance Level
You can adjust the balance of the P 3 with the < Balance > buttons on the front panel.
Each press of a button in either direction increases the relative balance in 2 dB increments
Adjusting Balance toward the Right Channel
Press the Balance > button once to show the present balance level in the display.
The next time you press the Balance > button it will change the balance.
Keep pressing the Balance > button until the desired balance is reached. Each time
you press the Balance > button, the right channel level will increase by 2 dB.
Adjusting Balance toward the Left Channel
Press the < Balance button once to show the present balance level in the display.
The next time you press the < Balance button it will change the balance.
Keep pressing the < Balance button until the desired balance is reached. Each time
you press the < Balance button, the left channel level will increase by 2 dB.
17
1
2
3
4
5
6
1
1
2
3
4
5
6
See page 19 for P 3 Front Panel and Remote Control layout