Filter
Top Products
10
VQT2W18
STEP 1 : Preparing the speakers
Caution
≥ Do not stand on the base. Be cautious when children are
near.
≥ When carrying speakers, hold the stand and base parts.
Preparation
≥ To prevent damage or scratches, lay down a soft cloth and
perform assembly on it.
≥ For wall mount, refer to page 41.
≥ Keep the screws out of reach of children to prevent
swallowing.
∫ Preventing the speakers from falling
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm (
3
/32q), which is capable of supporting over 10 kg (22 lbs).
A String (not supplied)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not supplied)
D Wall
E Approx.150 mm (5
29
/32q)
Assembling the speakers [BTT750]
2 Front speakers 2 Stands (with cables) 2 Bases 4 Screws A 2 Screws B
A B
1
2
2
1
Tighten
securely.
Insert the wire fully.
r: White
s: Blue line
Push!
Leave about 80 mm (3
5
/32q)
Tighten securely.
Screw A
Press into the groove.
Screw B
Pull the cable
straight along
the line and
slide into the
groove.
Back of the base
SC-BTT750_350P_VQT2W18_eng.book 10 ページ ２０１０年６月２１日 月曜日 午後４時５１分