Filter
Top Products
ENGLISH
ENGLISH
9
RQT8043
RQTX0038
GETTING STARTED
7 Preventing the speakers from falling
• You will need to obtain the appropriate screw eyes to
match the walls or pillars to which they are going to be
fastened.
• Consult a qualifi ed housing contractor concerning the
appropriate procedure when attaching to a concrete
wall or a surface that may not have strong enough
support. Improper attachment may result in damage to
the wall or speakers.
Speaker assembly
Preparation
• To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
• For assembly, use a Phillips-head screwdriver.
• There is no difference between the right and left speakers and stands.
• For optional wall mount (\ page 10).
Make sure you have all the indicated components before starting assembly, setup, and connection.
*1
2 Front speakers
*1
2 Stands (with cable)
*1
2 Bases
*1
8 Screws
*2
2 Front speakers and
2 Surround speakers
*2
4 Stands
• 2 x stands with short cables:
For front speakers
• 2 x stands with long cables:
For surround speakers
*2
4 Bases
*2
16 Screws
*1
For Continental Europe, Australia and N.Z.
*2
For Southeast Asia, Thailand, the Middle East, South Africa, Saudi Arabia and Kuwait
2
1
3
Tighten securely.
4
5
Slide into the
groove.
1
2
1
Position the cable
between the ridges.
5 Press into the groove.
3 Tighten securely.
4 Insert the wire fully.
+: White
−: Blue
Push!
Leave about 80 mm
2
1
2
3 Press into the groove.
1 Tighten securely.
2 Insert the wire fully.
+: White
−: Blue
Push!
Leave about 100 mm
You can remove and use the
cable from the stand. To reattach
the cable (\ page 10).
Attach the
speaker.
Thread the speaker cable through
the base.
Speaker assembly option
String (not included)
Thread from the wall to the
speaker and tie tightly.
Rear of the speaker
Screw eye
(not included)
Wall
Approx.
150 mm
RQTX0038-3B.indd 9RQTX0038-3B.indd 9 4/2/07 1:45:35 PM4/2/07 1:45:35 PM