Filter
Top Products
14
RQT8549
Before playback
Points regarding speaker sizes (á page 31)
The factory-set speaker size is “SMALL”.
You can set the lowpass filter frequency according to the playback frequency when the speaker size is “
SMALL
”. (The factory-set lowpass filter frequency is 100 Hz.)
See “Setting speakers and their sizes” for changing the speaker size to “LARGE ”.
AUTO SPEAKER
DETECTOR
ADVANCED
DUAL AMP
BI-AMP
WIRELESS
READY
POWER
SPEAKERS
AB
AUTO SPEAKER
DETECTOR
MULTI CH
SURROUND
AUX
S VIDEO IN
VIDEO IN
L
AUD
I
O
IN
R
MENU
SETUP
RETURN
INPUT SELECTOR
ENTER
VOLUME
HDMI
TUNE
POWER
SPEAKERS
AB
AUTO SPEAKER
DETECTOR
[ ]
AUTO SPEAKER
DETECTOR
WIRELESS
READY
Detecting speakers automatically
The unit checks each speaker’s connection status and make speaker settings automatically.
Perform the following steps when you connect a new speaker.
The unit considers seven speakers and one subwoofer are connected to the unit (keeps factory
settings) unless you perform these steps.
You can also make speaker settings manually (á page 31 “Setting speakers and their sizes”).
1
Turn the unit on.
Press
• The standby indicator [^] goes off when you turn
the unit on.
2
Check the speaker presence.
Press simultaneously.
Automatic speaker detection starts.
(The [AUTO SPEAKER DETECTOR] indicator
begins to flash when you press the buttons.)
(The [AUTO SPEAKER DETECTOR]
indicator goes off when detection is through.)
The unit checks the center speaker, surround speakers,
surround back speakers and the subwoofer in that order.
(The connection status for front speakers is always present.)
The display shows the number of detected speakers
(excluding the subwoofer).
The display shows connected speakers.
Automatic speaker detection ends.
• Automatic detection does
not work well depending
on speakers and cables.
Make speaker settings
manually in such cases
(á page 31).
• These settings remain
effective after the unit goes
off.
When you connect surround speakers to the unit wirelessly using SH-FX50/SH-FX60 (
á
page 12)
• The connection status for “S ” becomes present when the unit performs automatic
speaker detection.
“WARNING ” messages may appear on the display depending on detection results.
The unit did not detect the left surround back speaker.
Use the terminal for the left speaker when you connect
one surround back speaker only (á page 11).
The unit did not detect left and right surround
speakers. Connect surround speakers as well when
you connect surround back speakers to the unit.
The unit did not detect one of the two surround
speakers. Check speaker connections.
O
N
E
T
O
U
C
H
P
L
A
Y
D
I
R
E
C
T
N
A
V
I
G
A
T
O
R
T
O
P
M
E
N
U
F
U
N
C
T
I
O
N
S
0
RECEIVER
AV
SYSTEM
TV
RECORDER
DVD
DVD
PLAYER
ANALOG 6CH
VCRCD
TUNER
BAND
CH
VOLUME
DIRECT TUNING
ENTER
SKIP
SLOW/SEARCH
STOP
PAUSE
PLAY
DRIVE SELECT
DVD RECORDER
CM SKIP
ENTER
SUB MENU RETURN
OFF
SUBWOOFER
TEST
TV
LEVEL
EFFECT
VOL
NEO
:
6
SFC
MUSIC MOVIE
DIMMER MUTING
TV/VIDEO
DISC
POWER
SPEAKERS
AB
AUTO SPEAKER
DETECTOR
AUTO SPEAKER
DETECTOR
AUTO SPEAKER
DETECTOR
Note
L: Front left C: Center R: Front right S Surround
SB Surround back W Subwoofer
How speakers are displayed