Panasonic PT-DW17KU Home Theater System User Manual


 
Using the remote control
ENGLISH - 27
Preparation
Using the remote control
Inserting and removing the
batteries
1) Open the cover.
(i)
(ii)
2) Insert the batteries and close the cover
(insert the
side rst).
z
When removing the batteries, perform the steps
in reverse order.
Setting Remote control ID
numbers
When you use the system with multiple projectors,
you can operate all the projectors simultaneously or
each projector individually using single remote control,
if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same
ID number on the remote control.
The ID number of the projector is set to [ALL] as
the factory default. When using a single projector,
press the <ID ALL> button on the remote control.
Also, you can perform control operations if you
push the <ID ALL> button on the remote control
even if you do not know the projector ID.
How to set
1) Press the <ID SET> button on the
remote control.
2) Within ve seconds, press the two-
digit ID number set on the projector
using the number (<0> - <9>) buttons.
z
If you press the <ID ALL> button, you can
operate the projectors regardless of the setting
of the projector’s ID number.
Attention
z
Since setting of the ID number on the remote
control can be performed even without the projector,
do not press the <ID SET> button carelessly. If the
number (<0> - <9>) buttons are not pressed within
ve seconds after the <ID SET> button is pressed,
the ID number returns to its original value before
pressing the <ID SET> button.
z
The ID number set on the remote control will
be stored unless it is set again. However, it will
be erased if the remote control is left with dead
batteries. Set the same ID number again when the
batteries are replaced.
Note
z
Set the ID number of the projector from the
[PROJECTOR SETUP] menu → [PROJECTOR ID]
(
page 99).
Connecting to the projector
with a cable
When you use the system with multiple projectors,
congure the units as in the following gure. Use a
commercial M3 stereo mini jack cable and connect
the other devices to the <REMOTE 1 IN>/<REMOTE
1 OUT> terminals of the projector.
The remote control is effective even in places where
an obstacle stands in the light path or where devices
are susceptible to outside light.
Connecting terminals
Connecting to a
second projector
M3 stereo mini jack cable
(commercially available)
Remote control
Connects to the remote
control wired terminal
Attention
z
Use a cable that is 15 m (49'2") or shorter, with 2
core shield. The remote control may not operate
when the length of the cable exceeds 15 m (49'2")
or when the shielding of the cable is inadequate.