Panasonic PT-DW17KU Home Theater System User Manual


 
[PROJECTOR SETUP] menu
ENGLISH - 105
Settings
z
Error details
Error message Remedy
[Exceed maximum
number of projectors.]
z
Set no more than eight
projectors in one group.
z
Use a computer and
the dedicated “Multi
Projector Monitoring &
Control Software”
*1
to
connect nine or more
projectors.
[Please check the
COMMAND CONTROL
setting.]
z
Set the on-screen menu
[NETWORK CONTROL]
[COMMAND CONTROL]
to [ON] for the projector
in error.
z
Set the [NETWORK
CONTROL] [COMMAND
PORT] of all projectors
to be connected to the
same value.
[Please check the
USER NAME and
PASSWORD in the
COMMAND CONTROL
setting.]
z
Set the same character
string to the [User
name] and [Password]
that has Web control
administrator rights
for all projectors to be
connected.
[Cannot apply
BRIGHTNESS
CONTROL. Please
check projector status.]
z
The projector is in
standby status. Switch
on the projector.
[Brightness Sensor
Error]
z
There is a problem with
the luminance sensor.
If the problem is not
corrected by turning off
the power and turning it
on again, consult your
dealer.
*1: “Multi Projector Monitoring & Control Software” is included
in the attached CD-ROM.
Note
z
Check the following when a projector to be
connected is not listed.

Is there a device on the network with the same IP
address?

Is a LAN cable connected correctly? (
page 126)

Is the projector subnet identical?

Is [LINK] set to the same group?
z
To change a projector name, refer to [NETWORK
SETUP] (
page 125), or [Network cong] page
(
page 133).
z
When [MODE] in [BRIGHTNESS
CONTROL SETUP] is [PC]
0(18
5(7851
02'(
352-(&725
3&
%5,*+71(66&21752/67$786
(1) Displays the name of the projector in question.
(2) Uses color to display status.
Green
:
There is margin for brightness correction.
Yellow
:
There is less margin for brightness correction.
Red: An error occurred in luminance control.
Example steps to adjust
luminance control
The steps exemplify an adjustment to link the
brightness of eight projectors connected in a network.
1) Use a LAN cable to connect all
projectors to a hub. (
page 126)
2) Switch on all projectors.
3) Set [LAMP SELECT] to either [DUAL]
or [SINGLE] for all projectors.
4) Set [MODE] in [BRIGHTNESS
CONTROL SETUP] to [OFF] and
[APPLY].
5) Set [SUBNET MASK] of the projectors
to the same value, and [IP ADDRESS]
of each projector to a different value
so that the network can communicate.
6) Wait at least eight minutes until the
lamp brightness becomes steady.
7) Set all items in the [PICTURE] menu of
all projectors to the same values.
8) To match colors, adjust [COLOR
MATCHING].
9) Display the internal test patterns of all
projectors in completely white”.