Filter
Top Products
Precautions for use
16 - ENGLISH
Important
Information
■
Do not use the projector tilted to the right or left
Using the projector at a vertical angle that exceeds 15° may reduce product life or result in malfunction.
■
When installing and using the projector at an angle that exceeds 30°
vertically, set [COOLING CONDITION] (
page 100).
Failure to observe this will result in malfunctions or shorten the life of the lamp or other components.
■
When a replacement lamp unit is used (for portrait mode), install it with the
terminals surface facing down
Do not use the projector tilted to the right and left, front and back.
Using the projector at an angle that exceeds 15° in either direction may reduce product life or result in
malfunction.
■
Cautions when setting up the projector
z
When installing and using the projector with a method other than the oor standing installation using the
adjustable feet, x the projector using the six screw holes for ceiling mounting (see the gure below). (Screw
diameter: M6, tapping depth inside the set: 30 mm (1-3/16"), torque: 4 ± 0.5 N·m)
110
(4-11/32")
145
(5-23/32")
48
(1-7/8")
298 (11-23/32")
548 (21-9/16")
25 mm (31/32")
12 mm (15/32")
12 mm (15/32")
30 mm (1-3/16")
30 mm (1-3/16")
110
(4-11/32")
135.5
(5-11/32")
145
(5-23/32")
110
(4-11/32")
M6
M6
Bottom view
Model No. of ceiling mount bracket: ET-PKD510H (for high ceilings)
ET-PKD510S (for low ceilings)
Torque: 4 ± 0.5 N·m
Screw holes for ceiling mount
Screw hole depthMax. screw hole depth
Max. screw hole depth
Embedded nut
(Screw hole depth)
Space
Unit: mm