Filter
Top Products
RQT8046
22
The radio
Preset channels to make selection simpler. Up to 15 stations can each be preset in the FM and AM bands.
1 Tune to the frequency where presetting is to begin.
(⇒ see above)
2 Press and hold.
• “AUTO MEMORY” starts flashing.
• The tuner presets the stations it can receive into the channels in
ascending order. When finished, “SET OK” appears and the last
station to be preset is played.
1 Tune to the desired station. (⇒ see above)
2 Press.
“PGM” appears.
3 Within 10 seconds:
Select the channel.
The station occupying a channel is erased if another station is preset
in that channel.
1 Press [TUNER/AUX] to select “FM” or “AM”.
2 Press [PLAY MODE, –REPEAT] to select “PRESET”.
3 Press the numbered buttons or [u2/REW] or [i1/FF] to select
the channel.
Preset tuning
Automatic presetting Manual presetting
Selecting channels
Playing back
1 Select “FM” or “AM”.
2 Select “MANUAL”.
3 Select the frequency of the desired station.
4 Adjust the volume.
• Press and hold [u 2/REW] or [i 1/FF] until the frequency starts scrolling to start automatic
tuning. Tuning stops when a station is found.
• “STEREO” is displayed when a stereo FM broadcast is being received.
n If noise is excessive in FM
Press and hold [PLAY MODE, –REPEAT] to display “MONO”.
To cancel, press and hold [PLAY MODE, –REPEAT] again.
The mode also cancels when you change the frequency.
n FM frequency step (main unit only)
You can change the frequency step (0.2 MHz or 0.1 MHz).
1. Select “FM”.
2. Press and hold [TUNER/AUX] on the main unit.
After a few seconds, “FM” starts flashing on the display. Continue to hold the button down. The
minimum frequency changes and the step is changed.
• To return to the original step, repeat the above steps.
• Any preset stations are cleared by this procedure. Preset them again.
Manual tuning
MANUAL PRESET