Filter
Top Products
1514
15
RQT8164
Selecting the surround field
ENGLISH
Using the transmitter and headphones
14
RQT8164
When you remove the headphones,
the power turns off automatically
(Auto power on/off function).
Do not pull up the free-adjusting band when not
using the headphones. This may cause the auto
power on/off function to switch the headphones
back on and battery power to run down.
If no audio signal is received at the transmitter for more than 5 minutes
(approximately)
The infra-red rays being emitted from the transmitter automatically stop and the transmitter’s
POWER/CHARGE lamp goes out. These infra-red rays start being emitted again when an audio
signal is received. When the input audio (analog only) continues to be very low for more than 5
minutes (approximately), the infra-red rays being emitted from the transmitter may stop. If this
happens, increase the volume level on the connected equipment and decrease the volume level on
the headphones.
If a noise signal is input from equipment connected by the LINE IN terminal, the output of infra-red
rays may be stopped.
• The brightness of the transmitter’s infra-red signal transmission window may not be uniform. This will not effect, for
example, the range of the infra-red rays.
• Use the headphones within the range of the infra-red rays ( page 11 [Placement of transmitter and
headphones]).
• The actual location of the sound may be difficult to recognize with music and audio only sources such as music CDs.
• This unit simulates an average person’s HRTF*. However individual differences in human’s HRTF means that the
effect of this system will vary between individuals.
*An abbreviation for Head Related Transfer Function.
NOTE
When playing sports game sources. Reproduces the
excitement of being in a stadium at a noisy sports scene
while making the sound of the announcer or commentator
easier to hear.
VOICE
Press and hold [SURROUND] to select
the desired surround mode.
Press and hold
SURROUND
MUSIC
CINEMA
VOICE
OFF MUSIC CINEMA VOICE
• Depending on the signal being input, volume may vary when changing between surround modes.
• There is no surround effect when playing a monaural source.
• The SURROUND lamp for the selected
mode will come on.
• This will go off, if [OFF] is selected.
NOTE
Surround mode Surround mode and suitable input source
When playing movie sources for greater audio impact.
Creates a feeling close to being actually part of the scene.
When playing music sources for enhanced acoustics.
For normal headphone playOFF
MUSIC
CINEMA
Free-adjusting
band