Filter
Top Products
63
EN
1A23
Others
8 Others
• Make sure to complete AUTOSCAN in SETUP WIZARD or EXTENDED
SCAN in SETUP menu. It will be required when you setup STB for the first
time or when STB is moved to a location where other channels are
broadcast.
• The selected channel does not exist at that time. There are not always sub-
channels being broadcast.
• When AUTOSCAN is interrupted and not completed, some channels will
not be received. Make sure to complete AUTOSCAN or EXTENDED
SCAN in SETUP menu.
• Many digital channels have alternate channel numbers. STB changes the
numbers automatically to the ones signifying the broadcasting stations.
• Some channels are not received with AUTOSCAN in SETUP menu. Use
EXTENDED SCAN for better results.
• Unplug the AC power cord and wait for approx. 5 seconds, then enter the
default number "0000."
• Change the TV setting to a mode other than VIDEO.
• Change channels through the TV.
•Turn off the power of the TV, then turn on the power again.
• This is a normal part of the start-up process and is not a malfunction.
• Scanning finds new channels, but it does not delete old ones. Delete
unwanted channels in ADD/DELETE in the SETUP menu.
No reception
The entered channel
number changes
automatically
No reception of channels
with weak signal
(AUTOSCAN)
When you forget the
password for V-CHIP
Closed captioning
display (TEXT mode)
does not go off even
after changing channels
through STB.
The screen goes blank
just after turning the
STB on.
Channels without a signal
remain after scanning
with AUTOSCAN or
EXTENDED SCAN.
Symptom Remedy
ST300UA.qxd 04.8.3 1:13 PM Page 63