Filter
Top Products
Some messages are displayed on the screen during
channel changing or during programs.
When STB cannot receive a channel signal, the
whole screen becomes gray, then NO SIGNAL
appears in the center.
This may occur when:
• the signal is too weak
(when using the Smart Antenna, it automatically
searches for the strongest signal.)
• the channel is not broadcasting
• the antenna cable is not connected
When STB is trying to receive a signal, the whole
screen becomes gray, then SCANNING appears in
the center.
When you have set V-CHIP and you receive a
program that meets any setting of yours, the whole
screen becomes gray, then RESTRICTED
PROGRAM appears in the center.
See “Setting MPAA rating” on page 51 or “Setting TV
rating” on page 53 for further information.
Press INFO to verify the rating of a program
currently being received.
Screen:
Remote:
The STB receives digital broadcasts with embedded
“broadcast flag” and enciphers them with the HDCP
system and outputs them from the DVI-D HDCP
jack.
Your television must also be HDCP-compliant to
view them via DVI jack. This message appears if
your television is not compliant with HDCP.
You can still view the program, by using another type
of video connection. See “TV/Monitor Connections”
for the alternatives and switch the output selection
switch (DVI/COMP.) on back of STB to COMP.
“Broadcast flags” are digital codes embedded in
digital broadcasting streams that signal the STB to
limit indiscriminate redistribution of content.
This program is protected and cannot be viewed on TV without
HDCP-compliant DVI.
To watch this program, select “COMP.” by DVI/COMP. Select Switch and use
video output other than DVI.
Cowboy
RESTRICTED PROGRAM
51-1
No description provided.
TV-14 D
No description provided.
ENGLISH
The rating of this program
RESTRICTED PROGRAM
SCANNING
NO SIGNAL
On screen messages
31
EN
1A23
Basic Operation
6 Basic
Operation
ST300UA.qxd 04.8.3 1:12 PM Page 31