Onkyo TX-SR603/603E Stereo Receiver User Manual


 
47
First Time Setup
—Continued
2
Use the Up and Down [ ]/[ ]
buttons to select 1. Speaker
Cong, and then press [ENTER].
The Speaker Cong menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select a. Subwoofer,
and then use the Left and Right
[ ]/[ ] buttons to select:
Yes:
Select if a subwoofer is con-
nected.
No:
Select if no subwoofer is con-
nected.
4
Use the Up and Down [ ]/[ ]
buttons to select b. Front, and
then use the Left and Right [ ]/
[ ] buttons to select:
Small:
Select if the front speakers are
small.
Large:
Select if the front speakers are
large.
Note:
If the Subwoofer setting in step 3 is set
to No, this setting is xed at Large.
5
Use the Up and Down [ ]/[ ]
buttons to select c. Center, and
then use the Left and Right [ ]/
[ ] buttons to select:
Small:
Select if the center speaker is
small.
Large:
Select if the center speaker is
large.
None:
Select if no center speaker is
connected.
Note:
If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
ENTER
ENTER
ENTER
ENTER
ENTER
6
Use the Up and Down [ ]/[ ]
buttons to select d. Surround,
and then use the Left and Right
[ ]/[ ] buttons to select:
Small:
Select if the surround left and
right speakers are small.
Large:
Select if the surround left and
right speakers are large.
None:
Select if no surround left and
right speakers are connected.
Note:
If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7
Use the Up and Down [ ]/[ ]
buttons to select e. SurrBack,
and then use the Left and Right
[ ]/[ ] buttons to select:
Small:
Select if the surround back
left and right speakers are
small.
Large:
Select if the surround back
speakers are large.
None:
Select if no surround back
speakers are connected.
Notes:
If the Surround setting in step 6 is set
to None, this setting cannot be
selected.
If the Surround setting in step 6 is set
to Small, this setting cannot be set to
Large.
8
Use the Up and Down [ ]/[ ]
buttons to select f. SurrBack
ch, and then use the Left and
Right [ ]/[ ] buttons to select:
1ch:
Select if one surround back
speaker is connected.
2ch:
Select if two (left and right)
surround back speakers are
connected.
Note:
If the Surround Back Setting in step 7 is
set to None, this setting cannot be
selected.
Continue with step 9 on page 48.
ENTER
ENTER
ENTER