Onkyo TX-SR603/603E Stereo Receiver User Manual


 
37
Connecting the AV Receiver
—Continued
With (Remote Interactive) you can control your
-compatible Onkyo CD player, DVD player, and so
on with the AV receivers remote controller, as follows:
To use , you must make an analog audio con-
nection between the AV receiver and the other AV
components, even if they are connected digitally.
Auto Power On/Standby
When you start playback on an AV component con-
nected via , if the AV receiver is in Standby, it will
turn on and select that AV component as the input source
automatically. Similarly, when the AV receiver is set to
Standby, all components connected via also enter
Standby. Note that this function will not work if the com-
ponents power cord is connected to the AV receivers
AC OUTLET.
Direct Change
When playback is started on an AV component con-
nected via , the AV receiver automatically selects
that AV component as the input source.
Remote Control
You can control your -compatible Onkyo compo-
nents with the AV receivers remote controller.
Notes:
If you connect an -compatible Onkyo MiniDisc
recorder or CD recorder to the TAPE IN/OUT jacks,
for to work properly, you must change the
TAPE/MD/CDR display (see page 52).
Push plugs in all the way to make good connections.
Use only cables for connections. No
cables are supplied with this AV receiver.
Some AV components have two jacks. You can
connect either one to this AV receiver. The other jack
is for connecting more -compatible components.
Connect the AV receivers jack to only Onkyo AV
components. Connecting to other manufacturers AV
components may cause them to malfunction.
Some components may not support all functions.
Refer to the manuals supplied with your components.
The AV receiver has an AC outlet on its rear panel for
connecting the power cord of another AV component.
The other components power switch can then be left in
the ON position so that it turns on or off when the AV
receiver is set to On or Standby.
Caution:
Make sure that the capacity of the component that you
connect to the AC OUTLET does not exceed the stated
capacity (e.g., 100 W).
Notes:
Onkyo components with jacks should be con-
nected directly to wall outlets, not the AV receivers
AC OUTLET.
The socket type and capacity will depend on the coun-
try in which you purchased the AV receiver.
Connecting Components
REMOTE
CONTROL
L
R
IN
L
R
L
R
AUDIO
OUTPUT
AUDIO
OUTPUT
L
R
IN
e.g., DVD player
e.g., MD recorder
Connecting the Power Cord of
Another Component
AC OUTLET
AC
120
V 60
Hz
SWITCHED
120W 1A MAX.
European and some
Asian models
North American
model