Onkyo TX-SR603/603E Stereo Receiver User Manual


 
44
First Time Setup
—Continued
Component Video Setup
If you connect to a COMPONENT VIDEO IN, you must
assign it to an input selector. For example, if you connect
your DVD player to COMPONENT IN 3, you should
assign it to the DVD input selector.
If you want to output composite and S-Video sources
from the COMPONENT VIDEO OUT, select VIDEO,
as explained below.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Minimum Speaker Impedance
(not North American models)
If the impedance of any of the connected speakers is 4
ohms or more, but less than 6 ohms, set the Minimum
Speaker Impedance to 4 ohms.
Note:
Before you change this setting, turn down the volume.
Input selector VIDEO IN jack
DVD IN 1
VIDEO 1 IN 2
VIDEO 2 IN 3
VIDEO 3 VIDEO
VIDEO 4 VIDEO
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select 0. Initial
Setup, and then press [ENTER].
The Initial Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and then use the Left and
Right [ ]/[ ] buttons to select:
IN1:
Use the video component
connected to COMPO-
NENT VIDEO IN 1.
IN2:
Use the video component
connected to COMPO-
NENT VIDEO IN 2.
IN3:
Use the video component
connected to COMPO-
NENT VIDEO IN 3.
RECEIVER
ENTER
ENTER
ENTER
VIDEO:
Output composite video
and S-Video sources from
the COMPONENT
VIDEO OUT.
4
Press the [SETUP] button.
The setup menu closes.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 39).
2, 3
1, 4
2
1