Filter
Top Products
27
Listening to the Radio
—Continued
■
Tuning into Stations by Frequency
You can tune into AM and FM stations directly by
entering the appropriate frequency.
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
■
Selecting Presets
■
Deleting Presets
The North American model changes FM frequency in
0.2 MHz steps, 10 kHz steps for AM. For other models
it’s 0.05 MHz steps for FM and 9 kHz (or 10 kHz) steps
for AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
1
Press the [DIRECT TUNING]
button.
(Actual display depends on country.)
2
Within 8 seconds, use the
number buttons to enter the
frequency of the radio station.
For example, to tune to 87.5 (FM),
press 8, 7, 5.
To cancel the number entry, press the
[CLR] button on the remote controller.
1
Tune into the AM/FM station that
you want to store as a preset.
2
Press the [MEMORY] button.
The MEMORY indicator appears and
the preset number flashes.
3
While the MEMORY indicator is
displayed (about 8 seconds), use
the number buttons on the
receiver to select a preset from 1
through 40.
Receiver
Remote
controller
Receiver
Remote
controller
MEMORY
TUNING MODE
PRESET
/
Number buttons
Receiver
Receiver
4
Press the [MEMORY] button
again to store the station or
channel.
The station or channel is stored and the
preset number stops flashing.
Repeat this procedure for all of your
favorite AM/FM radio stations and XM
channels.
1
To select a preset, use the
number buttons on the receiver,
or the remote controller’s
PRESET [ ]/[ ] buttons.
For the TX-8522 other than North
American model, the PRESET
[ ]/[ ] buttons on the receiver also
can be used to select a preset.
1
Select the preset that you want to
delete.
See the previous section.
2
While holding down the
[MEMORY] button, press the
[TUNING MODE] button.
The preset is deleted and its number
disappears from the display.
Receiver
Receiver
Remote
controller
Receiver
AUTOTUNED
FM STEREO