Filter
Top Products
20
Turning On the Receiver
For the buttons listed below, you can change the input
display name to “HDD.” When the input display name
has been changed to “HDD” for one of the buttons
below, the display name for the other button cannot be
changed to “HDD.”
TX-8522: TAPE 1, VIDEO
TX-8222: TAPE 1, LINE 2
After you changed the input display name to “HDD,”
you can operate the RI Dock using the remote controller
supplied with the receiver (see pages 10, 11).
STANDBY/ON
ON/STANDBY
STANDBY indicator
Turning On and Standby
1
Press the [STANDBY/ON] button.
Alternatively, press the remote
controller’s [ON/STANDBY]
button.
The receiver comes on, the display
lights up, and the STANDBY indicator
goes off.
To turn the receiver off, press the
[STANDBY/ON] button, or press the
remote controller’s [ON/STANDBY]
button. The receiver will enter Standby
mode. To prevent any loud surprises
when you next turn on the receiver,
always turn down the volume before
you turn it off.
or
STANDBY/ON
Receiver
Remote
controller
Changing the Input Display
1
Press the appropriate input
selector button.
The selected input name appears in the
display.
2
Press and hold down the input
selector button selected in the
Step 1 above for approximately 3
seconds to change the display
name to “HDD.”
1, 21, 2
or
TX-8522
TX-8222
or